Use of freezing techniques for increasing the output of ultralow density laser targets

Use of freezing techniques for increasing the output of ultralow density laser targets Научная публикация

Журнал

Instruments and Experimental Techniques
ISSN: 1608-3180 , E-ISSN: 0020-4412

Вых. Данные

Год: 2016, Том: 59, Номер: 2, Страницы: 321-324 Страниц : 4 DOI: 10.1134/s0020441216010309

Авторы

Pimenov V.G. ¹ , Sheveleva E.E. ¹ , Sakharov A.M. ¹

Организации

1	Zelinsky Institute of Organic Chemistry, Russian Academy of Sciences, Leninskii pr. 47, Moscow, 119991, Russia

Self-supporting ultralow density laser targets with an apparent density as low as 1 mg/cm3, a porous layer thickness of 60–500 μm, and a window diameter of 2.5 mm were prepared by thermally induced gelation of cellulose acetate solution in a mixture solvent between two glass slides using the mold casting method. In view of the low mechanical gel strength at a concentration of <0.2 wt %, supercritical drying of molded targets is carried out without separating the glass slides. For the target output to be radically increased, a new procedure has been developed based on rapid freezing of the solution on a metal brick from room temperature to–60°C and lower, down to–190°C, without initial gelation.

Pimenov V.G. , Sheveleva E.E. , Sakharov A.M.
Use of freezing techniques for increasing the output of ultralow density laser targets
Instruments and Experimental Techniques. 2016. V.59. N2. P.321-324. DOI: 10.1134/s0020441216010309 WOS Scopus OpenAlex

≡ Web of science:	WOS:000376260000024
≡ Scopus:	2-s2.0-84969765316
≡ OpenAlex:	W2357090446